Banner
619620082794
Order your ARB Compressor Bracket for Jeep JK today and move that compressor to its most suitable location
The ARB Compressor Bracket for Jeep JK will allow you to install your locker compressor in the only available spot in the crowded JK engine bay. It attaches to the brake master cylinder mounting studs with the factory hardware. It positions the compressor as high as possible and still allow the compressor to be installed upright. It is laser cut from 3/16" carbon steel plate and formed on a brake for accurate and repeatable results. Order your JK compressor bracket today and move that compressor to its most suitable location.
Reference: UCF670
Brand: Under Cover Fabworks
These aluminum hinges can be used to fabricate your own trail doors or to replace lost parts.
Reference: UCF529
Brand: Under Cover Fabworks
Replace those weak, sagging hinges with new HD pivots from UCF!
Reference: UCF634
Brand: Under Cover Fabworks
Make a cage tube removable with these flanges!
Reference: UCF521
Brand: Under Cover Fabworks
Protect the stock axle ends from bending in the harsh conditions you would see when rock crawling or desert racing.
Reference: UCF164
Brand: Under Cover Fabworks
Move your license plate off the corner of the Jeep to keep it safe.
Reference: UCF046
Brand: Under Cover Fabworks
Recovery Points that will take Serious Abuse
Reference: UCF394
Brand: Under Cover Fabworks
The Jeep TJ Parking Brake Bracket Kit was designed to mount a Wilwood master cylinder in place of the factory e-brake bracket on the TJ. This is very helpful in performing axle swaps with rear disk brakes.
Reference: UCF250
Brand: Under Cover Fabworks
Replace those weak, sagging hinges with new HD pivots from UCF!
Reference: UCF631
Brand: Under Cover Fabworks
Make a cage tube removable with these flanges!
Reference: UCF078
Brand: Under Cover Fabworks
Adjust the height of your LOPRO mount to accommodate custom transfer case skid installs.
Reference: UCF629
Brand: Under Cover Fabworks
Mount a winch to any flat surface with this heavy-duty fairlead bracket.
Reference: UCF651
Brand: Under Cover Fabworks
Our new Jeep JL Outer Tire Carrier Reinforcement Bracket is fabricated from 1/4" 6061-T651 aluminum plate for the ultimate in strength and performance
Reference: UCF650
Brand: Under Cover Fabworks
Our new Jeep JL Heavy-Duty Tire Carrier Bracket will safely support a 37 or 38" tire on a 17" plus diameter wheel.
Reference: UCF539
Brand: Under Cover Fabworks
Relocate your factory locker pumps to a UCF transfer case skid plate with this bracket.
Reference: UCF437
Brand: Under Cover Fabworks
Dress-up your QD steering wheel conversion with this aluminum cover plate!
Reference: UCF632
Brand: Under Cover Fabworks
Make a cage tube removable with these flanges!
Order your ARB Compressor Bracket for Jeep JK today and move that compressor to its most suitable location
