Reference: UCF641
Brand: Under Cover Fabworks
UCF JL Front Dana 30 M186 Heavy-Duty Differential Cover (Welded)
1/4" steel armor for your Dana 30 AdvanTEK M186 front axle, shipped fully welded and ready for paint.
619620084217
1/4" steel armor for your Dana 35 AdvanTEK M200 rear axle, shipped fully welded and ready for paint.
Welded rear cover for the JL Dana 35 M200.
This welded differential cover is for the Dana 35 M200 rear axle on non-Rubicon Wrangler JL models, and it trades the thin factory cover for steel that shields the gears. Look for M200 on your build sheet, since some have the M220.
Built to take a beating
What's included: Fully welded cover, fill plug and SAE mounting hardware. If your axle uses metric cover bolts, reuse your factory bolts.
Finish: ships as bare steel. Spray paint the outer surface before installing.
Fitment: confirmed vehicles
Not sure what you have? Choose your vehicle in the parts finder at the top of the page, or send us a photo of your axle and we'll help.
Install instructions: see the Attachments tab above, or download the UCF Differential Cover Install Guide (PDF).
Not sure which cover fits? See our Diff Cover Selection Guide.
Specific References
Reference: UCF641
Brand: Under Cover Fabworks
1/4" steel armor for your Dana 30 AdvanTEK M186 front axle, shipped fully welded and ready for paint.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF JL Rear Dana 35 M200 Heavy-Duty Differential Cover (Welded)
1/4" steel armor for your Dana 35 AdvanTEK M200 rear axle, shipped fully welded and ready for paint.
* Required fields
Review sent
Your review cannot be sent
1/4" steel armor for your Dana 35 AdvanTEK M200 rear axle, shipped fully welded and ready for paint.