Reference: UCF029
Brand: Under Cover Fabworks
UCF Dana 60 Heavy-Duty Differential Cover (Welded)
1/4" steel armor for your Dana 60 axle, shipped fully welded and ready for paint.
619620083500
The same 1/4" steel Dana 60 cover as a weld-it-yourself kit. Save money if you have a welder.
DIY kit for Dana 60 fronts and Dana 60/70 rears.
Weld this one yourself: the kit fits the 4WD Dana 60 fronts listed below plus Dana 60 and Dana 70 rear axles, which use the same bolt pattern. You get the same parts as our welded cover, tacked together and ready for your final welds.
What you get
If your axle uses metric cover bolts, reuse your factory bolts.
Install tips
Fitment: confirmed vehicles
Also fits Dana 60 and Dana 70 rear axles (the Dana 70 uses the same cover bolt pattern).
1999 and newer Ford Super Duty fronts take our Super Duty Dana 60 cover, which clears the tie rod.
Not sure what you have? Choose your vehicle in the parts finder at the top of the page, or send us a photo of your axle and we'll help.
Ships tack-welded together, so you know you have the right parts and they fit. You finish the welding.
Install instructions: see the Attachments tab above, or download the UCF Differential Cover Install Guide (PDF).
Not sure which cover fits? See our Diff Cover Selection Guide.
Specific References
Reference: UCF029
Brand: Under Cover Fabworks
1/4" steel armor for your Dana 60 axle, shipped fully welded and ready for paint.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF Dana 60 Heavy-Duty Differential Cover (DIY Kit)
The same 1/4" steel Dana 60 cover as a weld-it-yourself kit. Save money if you have a welder.
* Required fields
Review sent
Your review cannot be sent
The same 1/4" steel Dana 60 cover as a weld-it-yourself kit. Save money if you have a welder.