Reference: UCF503
Brand: Under Cover Fabworks
UCF Jeep TJ & LJ Steel Ultra-High Clearance Front Bumper
Gain inches of clearance on your approach.
619620083104
Heavy-duty carbon steel rear bumper with a built-in receiver and 3/4" D-ring mounts.
A heavy-duty rear bumper with a receiver.
This rear bumper is fabricated from carbon steel for a very strong product.
Construction and specs
What's included: Two-piece bumper (inner cross-member and outer cover), two lower plates that attach both to the frame at the ends, and the hardware that attaches the outer cover to the cross-member. Hardware to install the cross-member is not included; factory hardware can sometimes be reused. Tire carrier is not included.
Finish: ships raw, with no paint or powder coat, so you can finish it however you like.
Fits the CJ-7 with no trimming.
Fitment: confirmed vehicles
Not sure what fits your project? Choose your vehicle in the parts finder at the top of the page, or give us a call.
Install instructions: see the Attachments tab above, or download the UCF YJ, TJ & LJ Rear Bumper Install Guide (PDF).
Not sure which bumper fits? See our Bumper Selection Guide.
Specific References
Reference: UCF503
Brand: Under Cover Fabworks
Gain inches of clearance on your approach.
Reference: UCF469
Brand: Under Cover Fabworks
A 22 lb steel front bumper that saves serious weight over other rock bumpers.
Reference: UCF255
Brand: Under Cover Fabworks
A 27 lb steel front bumper that saves serious weight over other rock bumpers.
Reference: UCF438
Brand: Under Cover Fabworks
A dedicated crawler front bumper that gains all the clearance possible while keeping the winch tucked down low and as far back as possible.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF Steel Rear Bumper for Jeep YJ, TJ & LJ
Heavy-duty carbon steel rear bumper with a built-in receiver and 3/4" D-ring mounts.
* Required fields
Review sent
Your review cannot be sent
Heavy-duty carbon steel rear bumper with a built-in receiver and 3/4" D-ring mounts.