UCF Jeep TJ / LJ Rear Crossmember Bumper

Maximum rear clearance, hitch tucked in.

This rear bumper gains all the clearance possible while keeping the receiver tucked in and out of the rocks. The integrated receiver hitch works for vehicle recovery and accessory mounting.

Construction and specs

• Laser cut from a combination of 3/16" and 1/4" steel plate
• Fully MIG welded and ready to install
• Integrated receiver hitch
• 3/4" D-ring mounts welded on

What's included: One-piece bumper with studs welded inside, plus the nuts. It slips over the frame.

Install notes

• Trim your rear frame crossmember ends flush with the edge of the frame rails and bolt the bumper on. It can also be welded to the existing crossmember for even more strength.
• Notch the bottom center of the crossmember for receiver hitch clearance.
• You'll need a reciprocating saw or a grinder with a cut-off wheel.

Finish: ships raw, with no paint or powder coat, so you can finish it however you like.

Fitment: confirmed vehicles

• Jeep: Wrangler TJ 1997–2006 · Wrangler Unlimited LJ 2004–2006

Not sure what fits your project? Choose your vehicle in the parts finder at the top of the page, or give us a call.

Install instructions: see the Attachments tab above, or download the UCF TJ & LJ Rear Crossmember Bumper Install Guide (PDF).