Reference: UCF058
Brand: Under Cover Fabworks
UCF Dana 60 Rear Truss System
A rock-solid upper link mount for your Dana 60 rear axle. No welding to the cast center section.
619620082978
The easy way to swap a one-ton Dana or Sterling rear axle under your project.
One-ton Dana or Sterling rear swap for TJ and LJ.
Putting a one-ton Dana or Sterling rear axle under a TJ or LJ? This bracket kit lets it bolt to your factory-style control arms and other suspension parts once the brackets and tabs are welded to the housing.
What's included: all necessary brackets and tabs, plus a technical drawing showing the location and angle of every bracket.
The kit must be welded to the axle housing by a competent welder.
Finish: ships as bare, unpainted steel.
Fitment: confirmed vehicles
Fits these axles: Dana 60 rear, Sterling 10.25/10.5 rear.
Fits virtually any rear axle swap into a TJ or LJ: the housing must have a centered differential, and the axle tubes must be 3" to 3 3/4" in diameter. Measure your tubes before ordering.
Not sure what fits your project? Choose your vehicle in the parts finder at the top of the page, or give us a call.
Install instructions: see the Attachments tab above, or download the UCF TJ & LJ Dana/Sterling Rear Axle Bracket Kit Install Guide (PDF).
Specific References
Reference: UCF058
Brand: Under Cover Fabworks
A rock-solid upper link mount for your Dana 60 rear axle. No welding to the cast center section.
Reference: UCF579
Brand: Under Cover Fabworks
A rock-solid upper link mount for your Ford Sterling 10.25" or 10.5" rear axle. No welding to the cast center section.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF TJ & LJ Rear Axle Bracket Kit (Dana/Sterling)
The easy way to swap a one-ton Dana or Sterling rear axle under your project.
* Required fields
Review sent
Your review cannot be sent
The easy way to swap a one-ton Dana or Sterling rear axle under your project.