UCF Dana 60 Rear Truss System

Dana 60 rear truss with a 5" x 10" platform.

A link suspension on a Dana 60 rear axle needs a strong place for the upper links. This truss sits on tubes up to 3.13" and bolts to the diff cover, with no welds on the cast steel housing.

How it goes together

1. Weld the included tab to the included Dana 60 cover, then install the cover.
2. Set the truss body on the axle tubes.
3. Bolt the truss flange to the cover and weld the truss to the tubes.

Specs

• Link tab platform: 5" × 10"
• Platform to axle tube centerline: 6 7/8"
• Truss body: 1/2" carbon steel plate, heavy enough for any amount of horsepower
• Flange tying the truss to the cover: 3/8" steel plate, joined with 1/2" hardware

What's included: truss body, UCF Dana 60 heavy-duty diff cover with weld-on tab, diff cover hardware, and the 1/2" bolts and nuts that attach the truss to the cover.

Finish: ships as bare steel, so you can weld it on, place your link tabs and weld it all up.

Fitment: Dana 60 rear axles. Most trucks that came with a Dana 60 rear also came with other rear axles, so check the tag on your axle.

Tube size: saddles cut for axle tubes up to 3.13" diameter. Measure your tubes before ordering.

Not sure what you have? Choose your vehicle in the parts finder at the top of the page, or send us a photo of your axle and we'll help.

Install instructions: see the Attachments tab above, or download the UCF Rear Truss System Install Guide (PDF) and the UCF Differential Cover Install Guide (PDF).