UCF JK Rear Axle Bracket Kit (Sterling/Dana/Corporate 14 Bolt)

JK rear swap for Sterling, Dana or 14 Bolt.

This JK rear axle bracket kit is for a swapped Sterling, Dana 60 or GM 14 Bolt rear axle on a JK or JK Unlimited. Its brackets and tabs get the axle bolting to factory-style control arms and other suspension components.

• Laser cut from carbon steel plate
• Bent on a CNC press brake for a high degree of precision
• Bracket cutouts fit axle tubes from 3" to 3 3/4" in diameter

What's included: all necessary brackets and tabs, plus a technical drawing showing the location and angle of every bracket. A truss is not included.

The kit must be welded to the axle housing by a competent welder.

Finish: ships as bare, unpainted steel.

Fitment: confirmed vehicles

• Jeep: Wrangler JK 2007–2018 (with a swapped rear axle, centered housing, 3"–3 3/4" tubes) · Wrangler JK Unlimited 2007–2018 (with a swapped rear axle, centered housing, 3"–3 3/4" tubes)

Fits these axles: Sterling 10.25/10.5 rear, Dana 60 rear, GM 14 Bolt full-float rear.

Fits virtually any rear axle swap into a JK: the housing must have a centered differential, and the axle tubes must be 3" to 3 3/4" in diameter. Measure your tubes before ordering.

Not sure what fits your project? Choose your vehicle in the parts finder at the top of the page, or give us a call.

Install instructions: see the Attachments tab above, or download the UCF JK Rear Axle Bracket Kit Install Guide (PDF).