Banner
619620081735
Add strength, clean up the back of your Jeep frame, make room for rear wheelbase stretch and coil-over shocks.
The UCF Jeep TJ Back-Half Kit was designed to replace the back section of the frame from the up-sweeping section in front of the rear tire to the rear bumper. It includes a pair of 3/16" steel frame rails, a pair of 1/8" thick body-mount crossmembers and a 1/4" thick steel bumper. Also included are four 3/16" steel reinforcing plates that weld on either side of the back-half frame rails and the factory frame rails. This kit requires a 1" body lift.
This kit narrows the frame rails by 1.5" on each side to aid in clearing shocks of all types and creates a flat plane for extended rear wheelbase stretches.
It ships unassembled and must be welded up by the installer before installation onto the Jeep.
Reference: UCF611
Brand: Under Cover Fabworks
Stretch your 4th or 5th generation Mega Cab for a Longbed Conversion with the strongest kit available.
Reference: UCF422
Brand: Under Cover Fabworks
Add strength, clean up the back of your Jeep frame, make room for rear wheelbase stretch and coil-over shocks.
Reference: UCF581
Brand: Under Cover Fabworks
Add strength, clean up the back of your Jeep frame, make room for rear wheelbase stretch and coil-over shocks.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Add strength, clean up the back of your Jeep frame, make room for rear wheelbase stretch and coil-over shocks.
