Reference: UCF110
Brand: Under Cover Fabworks
UCF Long-Arm Bracket Kit for Jeep Wrangler TJ/LJ Unlimited
Correct your suspension geometry, gain ground clearance and skip skid plate modifications with this long-arm bracket kit.
619620082633
Replace those weak, bent-up factory lower control arm mounts with something beefy that keeps your cam bolts.
Possibly the strongest replacement lower control arm mount out there.
The axle-side lower control arm mount is usually the first part of the factory suspension to go. It rips off the axle on the trail and strands you at the worst possible time. These replacements weld to your Dana 30 or Dana 44 front axle and keep the factory cam bolts.
Other designs use flimsy horseshoe-shaped tabs to hold the cam bolts steady, and that's where all the force goes in hard braking or 4WD acceleration. Our bracket is designed so the cam bolt rests against its strongest part: the part welded directly to the axle tube.
What's included: one pair, enough to do a whole axle.
Finish: ships bare of paint, ready to weld onto your project.
Fitment: confirmed vehicles
Fits these axles: Dana 30 front, Dana 44.
For Dana 30 and Dana 44 front axles. Does not fit the JK (larger lower control arm bolt).
Not sure what fits your project? Choose your vehicle in the parts finder at the top of the page, or give us a call.
Reference: UCF110
Brand: Under Cover Fabworks
Correct your suspension geometry, gain ground clearance and skip skid plate modifications with this long-arm bracket kit.
Reference: UCF133
Brand: Under Cover Fabworks
Replace that bent passenger front upper control arm mount with this beast.
Reference: UCF142
Brand: Under Cover Fabworks
A chassis-side mounting system for the lower links of your four-link.
Reference: UCF477
Brand: Under Cover Fabworks
Replace damaged or removed frame-side rear upper control arm mounts.
Reference: UCF080
Brand: Under Cover Fabworks
A 3 3/4" long, 5/16" steel link tab for flat surfaces and UCF truss systems.
Reference: UCF081
Brand: Under Cover Fabworks
A 5/16" steel axle-tube link tab for axle tubes up to 3 1/2" in diameter.
Reference: UCF152
Brand: Under Cover Fabworks
A 1/4" steel coil-over mount that welds on where the axle tube meets the inner-C, for Dana 60 and other front axles.
Reference: UCF149
Brand: Under Cover Fabworks
A 1/4" steel coil-over tab curved to fit 1 1/2" round tube.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF Heavy-Duty Lower Control Arm Mounts for Jeep TJ, LJ & XJ
Replace those weak, bent-up factory lower control arm mounts with something beefy that keeps your cam bolts.
* Required fields
Review sent
Your review cannot be sent
Replace those weak, bent-up factory lower control arm mounts with something beefy that keeps your cam bolts.