Reference: UCF110
Brand: Under Cover Fabworks
UCF Long-Arm Bracket Kit for Jeep Wrangler TJ/LJ Unlimited
Correct your suspension geometry, gain ground clearance and skip skid plate modifications with this long-arm bracket kit.
619620082541
A 1/4" steel coil-over mount that welds on where the axle tube meets the inner-C, for Dana 60 and other front axles.
Coil-over mounting right at the inner-C.
This mount welds on where the axle tube meets the inner-C forging. Its bottom is profiled to fit both the tube and the inner-C, so you can mount a coil-over or ORI strut to the top of your axle tube with the bolt perpendicular to the tube centerline, as far out as possible while leaving room for the high-steer arm at full articulation.
What's included: One mount. The shock or strut and hardware are not included.
Finish: ships as bare, unpainted steel.
Fitment: Dana 60 front axles, including Ford, GM, Super Duty, Spicer Ultimate and Dynatrac Pro Rock 60.
Building a different front axle with a welded inner C? This tab works on most of them for a coil-over or ORI strut. You may need to touch up the profile slightly for a perfect fit.
Reference: UCF110
Brand: Under Cover Fabworks
Correct your suspension geometry, gain ground clearance and skip skid plate modifications with this long-arm bracket kit.
Reference: UCF423
Brand: Under Cover Fabworks
Mount TJ rear coil springs on any project with a 2.5" wide frame rail.
Reference: UCF157
Brand: Under Cover Fabworks
A chassis-side lower link mount for a triangulated four-link with 3/4" heims.
Reference: UCF150
Brand: Under Cover Fabworks
A 1/4" steel coil-over tab curved to fit 1 3/4" round tube.
Reference: UCF147
Brand: Under Cover Fabworks
A 6" long, 5/16" steel link tab for flat mounting surfaces.
Reference: UCF024
Brand: Under Cover Fabworks
Replace those weak, bent-up factory lower control arm mounts with something beefy that keeps your cam bolts.
Reference: UCF142
Brand: Under Cover Fabworks
A chassis-side mounting system for the lower links of your four-link.
Reference: UCF436
Brand: Under Cover Fabworks
An axle-side upper link mount with a 0 degree angle, for a 3-link front or a parallel 4-link rear.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
UCF Inner-C Coil-Over Mount for Front Axles
A 1/4" steel coil-over mount that welds on where the axle tube meets the inner-C, for Dana 60 and other front axles.
* Required fields
Review sent
Your review cannot be sent
A 1/4" steel coil-over mount that welds on where the axle tube meets the inner-C, for Dana 60 and other front axles.