Banner
619620082541
Coil-Over Shock Mounting Solutions
The UCF Flat-Bottom Coil-Over Tab is laser cut from 1/4" carbon steel plate. The bolt hole is 1/2" in diameter. The lower surface is flat to allow for shock mounting to the top of your axle tube with the bolt positioned perpendicular to the tube centerline and as far out as possible while leaving room for the high-steer arm at full articulation. The distance from the lower surface to the center of the bolt hole is 4".
Reference: UCF133
Brand: Under Cover Fabworks
Replace that bent passenger front upper CA mount with this beast.
Reference: UCF148
Brand: Under Cover Fabworks
Coil-Over Shock Mounting Solutions
Reference: UCF151
Brand: Under Cover Fabworks
Coil-Over Shock Mounting Solutions
Reference: UCF654
Brand: Under Cover Fabworks
These beefy tabs are designed to be a bombproof link attachment point for your tube chassis.
Reference: UCF477
Brand: Under Cover Fabworks
Jeep TJ Frame-Side Rear Upper Control Arm Mounts
Reference: UCF011
Brand: Under Cover Fabworks
Replace those weak and bent-up factory LCA mounts with something beefy
Reference: UCF150
Brand: Under Cover Fabworks
Coil-Over Shock Mounting Solutions
Reference: UCF436
Brand: Under Cover Fabworks
Simplify your link suspension build with our line of ready-made link mounting brackets!
Reference: UCF110
Brand: Under Cover Fabworks
Correct suspension geometry, improve ground clearance, and avoid skid plate modifications with our long-arm bracket kit.
Reference: UCF423
Brand: Under Cover Fabworks
These coil spring mounts will allow you to mount TJ rear springs on any vehicle with a 2.5" wide frame rail.
Reference: UCF147
Brand: Under Cover Fabworks
Link Mounts for Flat Surfaces
Reference: UCF157
Brand: Under Cover Fabworks
Lower Chassis-Side Link Mounting System for Triangulated Four-Link
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Coil-Over Shock Mounting Solutions
