UCF Dana 35 Rear Truss System

Upper link platform for the Dana 35 rear.

This Dana 35 rear truss gives your link suspension a 4" x 10" platform for the upper links. It ties into both axle tubes and the diff cover, so you never weld to the cast steel housing.

How it goes together

1. Weld the included tab to the included Dana 35 cover, then install the cover.
2. Set the truss body on the axle tubes.
3. Bolt the truss flange to the cover and weld the truss to the tubes.

Specs

• Link tab platform: 4" × 10"
• Platform to axle tube centerline: 6"
• Truss body: 1/2" carbon steel plate, heavy enough for any amount of horsepower
• Flange tying the truss to the cover: 3/8" steel plate, joined with 1/2" hardware

What's included: truss body, UCF Dana 35 heavy-duty diff cover with weld-on tab, diff cover hardware, and the 1/2" bolts and nuts that attach the truss to the cover.

Finish: ships as bare steel, so you can weld it on, place your link tabs and weld it all up.

Fitment: confirmed vehicles

• Jeep: Cherokee XJ 1984–2001 (with Dana 35 rear, others have a Chrysler 8.25 or Dana 44) · Comanche MJ 1986–1992 (with Dana 35 rear) · Grand Cherokee ZJ 1993–1998 (with Dana 35 rear) · Wagoneer XJ 1984–1990 (with Dana 35 rear) · Wrangler TJ 1997–2006 (non-Rubicon; with Dana 35 rear) · Wrangler YJ 1987–1995 (with Dana 35 rear)

Tube size: saddles cut for axle tubes up to 2.66" diameter. Measure your tubes before ordering.

Not sure what you have? Choose your vehicle in the parts finder at the top of the page, or send us a photo of your axle and we'll help.

Install instructions: see the Attachments tab above, or download the UCF Rear Truss System Install Guide (PDF) and the UCF Differential Cover Install Guide (PDF).